A hardware mouse jiggler — your mouse sits on a 3D-printed stand while an Arduino-driven servo twitches a textured disk under its sensor, keeping the computer awake with no software installed.

Overview
Awake Jiggler keeps a computer from sleeping or going idle, entirely in hardware. The mouse sits in a custom pocket on a small 3D-printed stand. Under its optical sensor, a grooved disk mounted on a micro servo turns 6° and back every 30 seconds. The sensor reads that as real movement, so the cursor wiggles a pixel or two and returns to where it was.
One button toggles it on and off, with the Arduino's onboard LED showing its state. There's nothing to install on the computer, so it works on any machine, including locked-down ones.
Key Features
Challenge
The disk has to sit close enough under the sensor to register — but never touch the mouse — and the mouse has to stay put so its sensor always lands on the textured ring. It also needed to be buildable from a standard Arduino kit with no breadboard, no extra resistors and no separate power supply, and print without supports.
Solution
I modeled the whole device as a parametric Fusion 360 script: base, lid and disk, plus the servo, button, Arduino Uno, the actual mouse and every jumper wire in its real color. The lid has a mouse-shaped pocket 1.5 mm deep with 0.75 mm clearance, holding the sensor over the disk's ring about 11 mm off-center, with the disk 0.6 mm below the pocket floor. The disk presses straight onto the servo spline and is clamped with a single screw, and the button uses the Arduino's internal pull-up. The Arduino sketch handles debouncing, the on/off toggle and the timed nudge, and the same script renders a captioned animation of the assembly and operation.
Results
A small, quiet device that prints in about 100 cm³ of PLA with no supports, assembles from common kit parts in minutes, and works on any computer. Every dimension is a named constant, so it can be refit to a different mouse or servo by changing a number and re-running the script.
In Motion
Gallery


